Hot Dip Galvanized Prefabricated Water Tank

The hot-dip galvanized prefabricated water tank is a new type of water tank manufactured according to 92SS177. The manufacturing and installation of this product are not affected by civil construction, and do not require welding equipment. The surface is treated with hot-dip zinc anti-corrosion, which is beautiful and durable, prevents secondary pollution of water quality, is beneficial to human health, and meets the requirements of standardization, serialization, and industrialization of building products.

This product is made of Q235 steel plate, stamped to form 1000x1000 and 1000x500 standard blocks, drilled around the
edges, hot-dip galvanized, and installed on site. During assembly, non-toxic rubber pads are sandwiched between the
standard blocks and bolted together.

This product is suitable for storing and regulating water tanks for building water supply, expansion and condensation
water tanks for heating systems, as well as temporary water storage tanks for construction, geological exploration,
industrial, and national defense projects.
The water storage capacity ranges from 1.0 cubic meter to 1000 cubic meters, and the height can reach 5 meters.

The diameter and position of the inlet pipe, outlet pipe, and overflow pipe of the galvanized steel plate water tank are
determined by the design; There should be a channel of no less than 7000mm around the water tank, and the bottom
and accessories of the tank should be hot-dip galvanized.

Water filling test: After assembling the water tank, close the outlet and drain pipes, open the inlet pipe, and check while
draining water until it is full. If there is no water leakage after 2-3 hours, it is considered qualified.
The bottom and sides of the 1-meter-high water tank are 3.0mm.

The bottom of the 2-meter-high water tank is 3.0mm on the side
A 3-meter-high water tank bottom with a 3.0mm side profile
The bottom of the 4-meter-high water tank is 5.0mm on the side, and 3.0mm on the second, third, and fourth floors.